Table of Contents
Advertisement
Configuring H248 Timers (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 291: Traffic Management Configuration Details (continued)
Task
Configure the sustained data
rate for streams of any
protocol, including RTP.
You can configure H.248 timers for the PGCP connection using the H248 Timers option.
To configure H248 timers in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 292 on page 486.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1.
Click Sustained Data Rate next to Traffic Management.
2. In the Comment box, enter the comment.
3. From the Default list, select the default value for sustained
data rate.
Range: 125 through 4,294,967,295 bytes per second
4. Expand Sustained Data Rate.
5. Click Rtcp next to Sustained Data Rate.
6. In the Comment box, enter the comment.
7. Expand Rtcp.
8. Click Percentage next to Rtcp.
9. Select one of the following:
percentage—if the value entered is a percentage of the
RTP's gate rate.
fixed-value—if the value entered is a fixed number of bits
per second.
Range: 0 through 2147483647
Chapter 23: Configuring Services
485
Advertisement
Table of Contents
