Configuring A Policy (Nsm Procedure); Table 241: Policy Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Configuring a Policy (NSM Procedure)

Table 241: Policy Configuration Details

Option Function
policy
Name Specifies the name of the policy.
Comment Supplies a descriptive comment for the policy.
Description Specifies a text description for the IPsec policy.
Proposal Set Specifies the type of default IPsec proposal set.
policy > Perfect Forward Secrecy
Comment Supplies a descriptive comment for the perfect
forward secrecy option. This is optional.
Copyright © 2010, Juniper Networks, Inc.
Enter a comment in the Ipsec workspace that describes the IPsec.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the IPsec parameters.
You can now configure the following options:
Configuring a Policy (NSM Procedure) on page 409
Configuring Traceoptions (NSM Procedure) on page 410
Configuring a VPN (NSM Procedure) on page 410
Configuring VPN Monitor Options (NSM Procedure) on page 413
To configure the policy option:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the policy option.
Click the Configuration tab. In the configuration tree, select Security > Ipsec > Policy.
3.
Add or modify settings as specified in Table 241 on page 409.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the policy settings.
Chapter 22: Configuring Security
Your Action
Enter the policy name.
(Optional) Enter a comment.
Enter a description.
Select the proposal set from the list.
Enter a comment.
409