Table of Contents
Advertisement
JUNOSe 11.1.x Physical Layer Configuration Guide
path ds1|e1 snmp trap link-status
Configuring T1 Interfaces to Send FDL Messages
You can configure a T1 interface to send FDL messages. To configure FDL:
1.
2.
3.
4.
5.
path ds1 fdl
128
Configuration Tasks
Use the no version to restore the default value.
See path ds1|e1 framing.
Use to enable SNMP link status processing for a T1 or an E1 interface and its
associated tributary.
The default is disabled.
Example
host1(config-controll)#path 2 ds1 1/1/1 snmp trap link-status
Use the no version to disable SNMP link status processing.
See path ds1|e1 snmp trap link-status.
Specify a SONET interface.
host1(config)#controller sonet 8/0
Specify the standard for transmission of FDL messages on both ends of the T1
connection.
host1(config-controll)#path 2 ds1 1/1/1 fdl ansi
(Optional) Configure the interface to operate in an FDL carrier environment.
host1(config-controll)#path 2 ds1 1/1/1 fdl carrier
(Optional) Specify the FDL messages.
host1(config-controll)#path 2 ds1 1/1/1 fdl string eic "ERX-1410"
host1(config-controll)#path 2 ds1 1/1/1 fdl string lic "Bldg 10"
host1(config-controll)#path 2 ds1 1/1/1 fdl string fic "GY788"
host1(config-controll)#path 2 ds1 1/1/1 fdl string unit 080001
Enable transmission of FDL messages.
host1(config-controll)#path 2 ds1 1/1/1 fdl transmit idle-signal
Use to specify the FDL standard for the interface.
Specify the keyword ansi to support the ANSI FDL standard (see "References"
on page 117).
Specify the keyword att to support the AT&T FDL standard (see "References"
on page 117).
Advertisement
Table of Contents
