Configure Interface Qos Chassis Shaping; Configure Interface Qos Disable-Qos - Avaya 2330 Reference Manual

[pvc <PVC>]
[no]
Example
AG/configure/interface/ethernet (0/3)/qos/chassis# service-policy
input map1

configure interface qos chassis shaping

Use this command to configure shaping parameters for outbound traffic on a chassis Ethernet
interface.
Syntax
shaping <value>
Table 202: Variable definitions
<value>
Example
AG/configure/interface/ethernet (0/3)/qos/chassis# shaping 100

configure interface qos disable-qos

Use this command to enable or disable QoS for all the applicable interfaces.
Syntax
[no] disable-qos
Table 203: Variable definitions
[no]
Command Line Reference
Variable
Variable
Variable
configure interface qos chassis shaping
Value
Specifies the PVC identifier for Frame Relay
interfaces: 16-1022.
Removes the policy map from that
interface.
Value
Value of the interface bandwidth in kbps;
Default value is 50000.
Value
Re-enables QoS at interface level.
August 2013 207