New Holland T8010 Manual page 1160

Hide thumbs Also See for T8010:

Table of Contents

Pinch the clamp with a pliers to open it and move it to

the side. Disconnect the heater return line (1) from

the evaporator heater core.

Loosen the clamp and disconnect the short hose (2)

between the heater valve and evaporator/heater

core. Be prepared to collect a small amount of

coolant that will drain into the HVAC box.

Remove the two screws securing the blower speed

driver and its mounting plate at the rear of the box.

Remove the 6-pin connector from the driver and

move the blower driver assembly out of the way.

Remove the evaporator temperature sensor from the

evaporator/heater assembly.

Section 50 - Climate Control - Chapter 2

Chapters

Table of Contents

T8020 T8030 T8040