New Holland T8010 Manual page 1161

Hide thumbs Also See for T8010:

Table of Contents

Section 50 - Climate Control - Chapter 2

Remove the evaporator top gasket and save for

reinstallation. Remove the grommet (1) and sensor

harness from the evaporator by sliding it out of the

slot opening.

NOTE: The gasket seals the top of the evaporator

and forces the air to move through the core rather

than around it. Replace the gasket if it is worn or

Slide the evaporator assembly straight up and out of

its side mounting brackets.

Put the assembly on a clean bench. Remove the

expansion valve from the evaporator heater core.

Use the two wrench, two hand method when

removing the thermal expansion valve to prevent

damage to the tubes.

Chapters

Table of Contents

T8020 T8030 T8040