Cab Recirculation Air Filter Service - New Holland T8010 Manual

STEP 204
Clean the filter element by one of two methods:
A. Tap the outside of the filter. This method can
be used to clean the filter when most of the dirt
is dust. Tap the filter against a flat surface. Do
not use force that can cause damage to the
filter.
B. Clean with compressed air. The compressed
air method is used if most of the dirt is dust.
Direct the air flow from the inside of the filter
outward.
IMPORTANT: The maximum air pressure at the
nozzle must not be more than 35 PSI (242 kPa). Too
much air pressure will cause damage to the filter.
IMPORTANT: Do not use a washing method with
filter washing compound to clean the filter.

CAB RECIRCULATION AIR FILTER SERVICE

STEP 205
A. Remove the vent and the recirculation air filter
on both sides of the operators seat.
B. Clean the filter as frequently as required by
operating conditions or whenever the cab air
filter is serviced.
C. Use mild soap and water. Rinse with clear
water and squeeze out the excess.
D. Reinstall the filters and vents.
NOTE: Never place objects
recirculation vents that could block air flow.
Section 50 - Climate Control - Chapter 2
in front of the
50-2-110
RH02H199
RH02J130