Connect A T1 /E1 Line - Lucent Technologies PortMaster PM-2 Hardware Installation Manual

5. Connect a T1 /E1 line

Follow these instructions to connect a T1 or E1 line to the W1 port of the PM-2R and
PM-2ER if you have already ordered the service from the telephone company.
Call your local telephone service provider to order T1 or E1. Typically you must pay an
installation charge, a monthly flat-rate service charge, and usage charges.
Note – The W1 port requires an external clock signal provided by the telephone
company or a channel service unit/digital service unit (CSU/DSU).
Required Equipment
A V.35, RS-530, or X.21 cable
One V.35 cable is included. (See "RS-232 Cable" on page B-10 for pinout
information.)
Procedure
1. Connect a line to the W1 port (PM-2R shown).
2. Ensure that the W1 port switch is set to V.35. This is the default (PM-2R shown).
Set the switch to RS-232 for an RS-232 cable.
Installing the PortMaster
S0 S1 S2 S3
S5 S6 S7 S8
RS-232
W1 V.35
W1
S0 S1 S2 S3
S5 S6 S7 S8
RS-232
W1 ETHERNET
V.35
RS-232
V.35
Connect a T1 /E1 line
S4
S9
ETHERNET
1189-0001
S4
S9
1189-0004
2-9