Examples Of Adsl-Dmt Interface Configuration; Figure 7-2 Adsl Atm Configuration - Lucent Technologies Stinger MRT 19 Getting Started Manual

Table of Contents

Advertisement

Examples of ADSL-DMT interface configuration

In Figure 7-2, an ADSL-DMT interface in a Stinger MRT 23 unit is configured to
support a rate-adaptive connection to a CellPipe™ 50A CPE. The Stinger MRT 19 is
configured to provide the same support in the same way. However the MRT 19 will
not have an associated switch in the central office, or POTS splitter at the customer
location, as shown for the MRT 23.
Figure 7-2. ADSL ATM configuration
Ethernet
POTS
The following commands configure the interface to use a constant, planned
(operator-controlled) bit rate of 56Kbps upstream and 1.5Mbps downstream, using
the fast channel in both directions:
admin> read al-dmt { 1 1 4 }
AL-DMT/{ shelf-1 slot-1 4 } read
admin> set enabled = yes
admin> set line-config line-latency-up = fast
admin> set line-config line-latency-down = fast
admin> set line-config rate-adapt-mode-up = operator-controlled
admin> set line-config rate-adapt-mode-down = operator-controlled
admin> set fast-path-config planned-bitrate-up = 56
admin> set interleave-path-config planned-bitrate-down = 1500
admin> write
AL-DMT/{ shelf-1 slot-1 4 } written
The following commands configure the interface to automatically select the best
possible rate at startup time. They specify a possible upstream bit-rate range of
56Kbps to 256Kbps and a possible downstream bit-rate range of 512Kbps to 1.5Mbps.
They also specify use of the interleaved channel in both directions.
admin> read al-dmt { 1 1 4 }
AL-DMT/{ shelf-1 slot-1 4 } read
admin> set enabled = yes
Stinger® MRT Getting Started Guide
POTS
SHELF
ALARM RELAY
BITS
ID
MODEM
LINE 1-24
LINE 25-48
SEE INSTRUCTION MANUAL
SIEHE ANLEITUNG
LIRE LE MANUEL d'INSTRUCTION
USE OF RING LUGS RECOMMENDED
DSL-Cell-50A
DSL
POTS
Copper
splitter
pair
Configuring the ADSL Line Interfaces
Examples of ADSL-DMT interface configuration
MINOR
CONSOLE
ETHERNET 10BT
EXP1
EXP2
STATUS
GROUP
PORT
1
5
SD
SD
6
10
LOS
LOS
SELECT
PORTS
PORT 1
MAJOR
POTS 25-48
Central office
switch or PBX
ATM
PORT 2
POTS 1-24
7-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stinger mrt 23

Table of Contents