Connect An Ethernet Cable; Ethernet 10Baset - Lucent Technologies PortMaster PM-2 Hardware Installation Manual

7. Connect an Ethernet Cable

The following Ethernet cables can be connected to the PortMaster. (See "Ethernet
Interface" on page B-5 for specifications.)
•

Ethernet 10BaseT

• Ethernet 10Base5 (AUI)
• Ethernet 10Base2 (BNC)
Ethernet 10BaseT
Follow these instructions to connect an Ethernet cable to the Ethernet 10BaseT port.
Required Equipment
A category 5 twisted pair cable, as specified by the EIA/TIA-568-B wiring
standard, with an RJ-48C connector
This cable is available from most computer equipment suppliers.
Procedure
1. Connect the cable to the Ethernet 10BaseT port (PM-2i shown).
2. Set DIP switches 4 and 5 up (PM-2i shown).
Installing the PortMaster
ISDN/U ISDN/U ISDN/U
S0-S1 S2-S3 S4-S5
C0 - DIAG
1189-0006
1187 0006
ISDN/U ISDN/U ISDN/U
S0-S1 S2-S3 S4-S5
C0 - DIAG
1 2 3 4 5
ISDN/U ISDN/U ISDN/U
S6-S7 S8-S9 HD
ETHERNET
ISDN/U ISDN/U ISDN/U
S6-S7 S8-S9 HD
ETHERNET
1189-0009
Connect an Ethernet Cable
2-11