Avaya S8700 Maintenance Manual page 597

status conference
Field Descriptions
The actual numbers that are dialed out by the administered connections for
Dial-Out
each channel in the call. Note that the dial Out #1 and #2 on page 1 of the
Number
forms display the DCP endpoint number. This is particularly useful with bonding
dial-out calls.
Indicates the current call state of the AC. The following are connection states
Connection
associated with dial-out ACs:
State
This field indicates how many retries have been attempted for this AC during
Retry Count
this join attempt. This field does not clear when the AC connects. However, it
clears when a new join attempt is made via a Redial feature. Note that this is
different from the
joined the conference during this conference session.
This field shows an ISDN or CPTR cause value (values lower than 0x7f)
Failure
recorded when the last dial out call was dropped. Values above 0x7f are
Cause
generated internally.
displayed by this field and its associated description. The
value is logged in the error log and can be displayed via the display errors
command. (
555-233-143
is transient in nature and indicates that an AC is about to enter
enabled—
the attempting to connect state.
disabled— this may mean one of three things:
— The AC has reached an administered retry threshold, and all
retries are stopped. Verify this by checking the error log and
checking whether an error type of 9 is logged against the AC.
— The AC was in a connected state and the far end disconnected.
— The initial channel call has not yet connected. No dial out call
attempt is made for the additional channel(s) until the initial
channel has reached a connected state.
not scheduled —is transient in nature and indicates that an AC is
about to enter the "attempting to connect" state.
waiting to retry—
waiting for the retry timer to expire. Once the timer expires, the AC sends a
dial out call and enters the "attempting to connect" state. ACs in this state
indicate that the dial out call has failed at least once.
attempting to connect—
the call has not yet connected.
—means that the call associated with the AC has been
connected
answered and join cut-thru to the conference.
Join Count
Table 7-49
Err Type is normally displayed as a decimal.)
means that the AC is inactive (sleeping) and
means that the AC is active on a call, but
which counts the number of times the channel
lists every possible failure cause value
Issue 1 May 2002
Failure Cause
7-341