Qos; Radius Authentication - Avaya G450 Cli Reference Manual

QoS

Table 73: QoS configuration CLI commands
Command
set qos bearer
set qos control
set qos signal
show qos-rtcp

RADIUS authentication

Table 74: RADIUS authentication configuration commands
Command
clear radius
authentication server
set radius authentication
set radius authentication
retry-number
set radius authentication
retry-time
set radius authentication
secret
set radius authentication
server
set radius authentication
udp-port
show radius authentication
Description
Permit the setting of VoIP QoS-bearer related parameters for the
Media Gateway Processor and VoIP engines
Define the source for QoS control parameters: local or remote
Set QoS signaling parameters (DSCP or 802.1Q) for the Media
Gateway Processor
Display QoS, RSVP, and RTCP parameters
Description
Clear the primary or secondary RADIUS server IP
address
Enable or disable RADIUS authentication
Set the number of times to resend an access request
when there is no response
Set the time to wait before resending an access request
Set the shared secret for RADIUS authentication
Set the IP address of the primary or secondary RADIUS
Authentication server
Set the RFC 2138 approved UDP port number
Display all RADIUS authentication configurations
(shared secrets are not displayed)
Issue 1 January 2008 113