Defaults
Refer to Parameters.
Command
CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority
command.
Parameters
priority-value
Defaults
1
Command
INTERFACE
Modes
Command
Version 9.2(0.0)
History
Usage
The router with the largest value assigned to an interface becomes the designated
Information
router. If two interfaces contain the same designated router priority value, the
interface with the largest interface IP address becomes the designated router.
ipv6 pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the
PIM-SM router from creating state based on multicast source and/or group.
Syntax
ipv6 pim join-filter access-list
Parameters
access-list
in
out
PIM-Sparse Mode (PIM-SM)
Introduced on the MXL 10/40GbE Switch IO Module.
Enter a number. Preference is given to larger/higher number.
The range is from 0 to 4294967294. The default is 1.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the name of an extended access list.
Enter the keyword in to apply the access list to inbound
traffic.
Enter the keyword out to apply the access list to outbound
traffic.
1035