Show Config - Dell MXL 10GbE Reference Manual

Parameters
priority
Defaults 100
Command VRRP
Modes
Command
Version 8.3.16.1
History
Usage
To guarantee that a VRRP group becomes MASTER, configure the VRRP group's
Information
virtual address with same IP address as the interface's primary IP address and
change the priority of the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal
to the interface's primary IP address, an error message appears.

show config

View the non-default VRRP configuration.
Syntax
show config [verbose]
Parameters
verbose
Command VRRP
Modes
Command
Version 8.3.16.1
History
Example
Dell(conf-if-vrid-4)#show con
vrrp-group 4
!
1350
Enter a number as the priority. Enter 255 only if the router's
virtual address is the same as the interface's primary IP
address (that is, the router is the OWNER). The range is from
1 to 255. The default is 100.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: Configuring VRRP priority 255 on an interface on which DHCP Client is
enabled is not supported.
(OPTIONAL) Enter the keyword verbose to view all VRRP
group configuration information, including defaults.
Introduced on the MXL 10/40GbE Switch IO Module.
virtual-address 119.192.182.124
Virtual Router Redundancy Protocol (VRRP)