Portmode Hybrid - Dell MXL 10GbE Reference Manual

•
•
•
•
•
Link Status Between Port 1 and Port 2
•
•
•
•
•
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
Related speed (for 1000/10000 interfaces)
Commands negotiate the speed.

portmode hybrid

To accept both tagged and untagged frames, set a physical port or port-channel. A port configured this
way is identified as a hybrid port in report displays.
Syntax
portmode hybrid
To return a port to accept either tagged or untagged frames (non-hybrid), use the
no portmode hybrid command.
Defaults non-hybrid
Command INTERFACE (conf-if-interface-slot/port)
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
The following describes the interface command shown in the following
Information
example. This example sets a port as hybrid, makes the port a tagged member of
VLAN 20, and an untagged member of VLAN 10, which becomes the native VLAN
of the port. The port now accepts:
•
•
The following describes the do show interfaces command shown in the
following example. This example shows output with "Hybrid" as the newly added
value for 802.1QTagged. The options for this field are:
1476
auto-negotiation enabled* speed 1000 or auto
auto-negotiation enabled speed 100
auto-negotiation disabled speed 100
auto-negotiation enabled speed 100
auto-negotiation disabled speed 100
Up at 1000 Mb/s
Up at 100 Mb/s
Up at 100 Mb/s
Down
Down
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
untagged frames and classify them as VLAN 10 frames
VLAN 20 tagged frames
— sets the link speed to 1000, 10000, or auto-
PMUX Mode of the MXL 10/40GbE Switch I/O Module