Maximum-Paths - Dell MXL 10GbE Reference Manual

Command ROUTER ISIS
Modes
Command
Version 9.2(0.0)
History
Usage
Change the maximum LSP lifetime with this command. The maximum LSP lifetime
Information
must always be greater than the LSP refresh interval.
The seconds parameter enables the router to keep LSPs for the specified length of
time. If the value is higher, the overhead is reduced on slower-speed links.
Related lsp-refresh-interval
Commands

maximum-paths

Allows you to configure the maximum number of equal cost paths allowed in a routing table.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number
Defaults 4
Command
•
Modes
•
Command
Version 9.2(0.0)
History
metric-style
To generate and accept old-style, new-style, or both styles of type, length, and values (TLV), configure a
router.
Syntax
metric-style {narrow [transition] | transition | wide
[transition]} [level-1 | level-2]
To return to the default values, use the no metric-style {narrow
[transition] | transition | wide [transition]} [level-1 |
level-2] command.
Intermediate System to Intermediate System (IS-IS)
Introduced on the MXL 10/40GbE Switch IO Module.
— sets the link-state packet (LSP) refresh interval.
Enter a number as the maximum number of parallel paths an
IP routing installs in a routing table. The range is from 1 to 16.
The default is 4.
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Introduced on the MXL 10/40GbE Switch IO Module.
821