Advertise Med Guest-Voice-Signaling - Dell MXL 10GbE Reference Manual

Parameters
vlan-id
layer2_priority
DSCP_value
priority-tagged
number
Defaults Unconfigured.
Command CONFIGURATION (conf-lldp)
Modes
Command
Version 8.3.16.1
History
Related
protocol lldp (Configuration)
Commands
debug lldp interface
show lldp neighbors
show running-config lldp

advertise med guest-voice-signaling

To advertise a separate limited voice service for a guest user when the guest voice control packets use a
separate network policy than the voice data, configure the system.
Syntax
advertise med guest-voice-signaling {vlan-id layer2_priority
DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med guest-voice-signaling
{vlan-id layer2_priority DSCP_value} | {priority-tagged number}
command.
Parameters
vlan-id
layer2_priority
DSCP_value
priority-tagged
number
Defaults unconfigured.
Command CONFIGURATION (conf-lldp)
Modes
Link Layer Discovery Protocol (LLDP)
Enter the VLAN ID. The range is from 1 to 4094.
Enter the Layer 2 priority. The range is from 0 to 7.
Enter the DSCP value. The range is from 0 to 63.
Enter the keywords priority-tagged followed the Layer 2
priority. The range is from 0 to 7.
Introduced on the MXL 10/40GbE Switch IO Module.
— enables LLDP globally.
— debugs LLDP.
— displays the LLDP neighbors.
— displays the LLDP running configuration.
Enter the VLAN ID. The range is from 1 to 4094.
Enter the Layer 2 priority. The range is from 0 to 7.
Enter the DSCP value. The range is from 0 to 63.
Enter the keywords priority-tagged then the Layer 2
priority. The range is from 0 to 7.
875