Track - Dell MXL 10GbE Reference Manual

track

Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled.
Syntax
track interface [priority-cost cost]
To disable monitoring, use the no track interface command.
Parameters
interface
cost
Defaults cost = 10
Command VRRP
Modes
Command
Version 8.3.16.1
History
Usage If the interface is disabled, the cost value is subtracted from the priority value and
Information forces a new MASTER election if the priority value is lower than the priority value in
the BACKUP virtual routers.
virtual-address
Configure up to 12 IP addresses of virtual routers in the VRRP group. To start sending VRRP packets, set at
least one virtual address for the VRRP group.
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the no virtual-address ip-
address1 [... ip-address12] command.
Parameters
ip-address1
1354
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For Port Channel interface types, enter the keywords
port-channel then the number. The range is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
(OPTIONAL) Enter a number as the amount to be subtracted
from the priority value. The range is 1 to 254. The default is
10.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter an IP address of the virtual router in dotted decimal
format. The IP address must be on the same subnet as the
interface's primary IP address.
Virtual Router Redundancy Protocol (VRRP)