Table of Contents
Advertisement
Parameters
Default
interface
Command
ROUTER OSPF for OSPFv2
Modes
ROUTER OSPFv3 for OSPFv3
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
By default, no interfaces are passive. Routing updates are sent to all interfaces on
Information
which the routing protocol is enabled.
If you disable the sending of routing updates on an interface, the particular address
prefix continues to be advertised to other interfaces, and updates from other
routers on that interface continue to be received and processed.
OSPFv3 for IPv6 routing information is not sent or received through the specified
router interface. The specified interface address appears as a stub network in the
OSPFv3 for IPv6 domain.
redistribute
Redistribute information from another routing protocol into OSPFv3 throughout the OSPF process.
Syntax
redistribute {bgp as number}{connected | static}[metric metric-
value | metric-type type-value] [route-map map-name] [tag tag-
value]
To disable redistribution, use the no redistribute {connected | static}
command.
Open Shortest Path First (OSPFv2 and OSPFv3)
Enter the keyword default to make all OSPF interfaces
(current and future) passive.
Enter the following keywords and slot/port or number
information:
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
•
For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Added support for OSPFv3.
Introduced on the MXL 10/40GbE Switch IO Module.
997
Advertisement
Table of Contents
