Pfc Link-Delay - Dell MXL 10GbE Reference Manual

Defaults 0x10
Command PROTOCOL LLDP
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage This command is available at the global level only.
Information

pfc link-delay

Configure the link delay used to pause specified priority traffic.
Syntax
pfc link-delay value
To remove the link delay, use the no pfc link-delay command.
Parameters
value
Defaults 45556 quantum
Command DCB INPUT POLICY
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage The minimum link delay must be greater than the round-trip transmission time a
Information peer must honor a PFC pause frame multiplied by the number of PFC-enabled
ingress ports.
Related dcb-input
Commands
pfc mode on
Enable the PFC configuration on the port so that the priorities are included in DCBX negotiation with peer
PFC devices.
Syntax
pfc mode on
To disable the PFC configuration, use the no pfc mode on command.
Defaults PFC mode is on.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
The range is (in quanta) from 712 to 65535. One quantum is
equal to a 512-bit transmission.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
— creates a DCB input policy.
1435