Priority-List - Dell MXL 10GbE Reference Manual

priority-list

Configure the 802.1p priorities for the traffic on which you want to apply an ETS output policy.
Syntax
priority-list value
To remove the priority list, use the no priority-list command.
Parameters
value
Defaults none
Command PRIORITY-GROUP
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage By default:
Information
•
•
Related
•
Commands
•
qos-policy-output ets
To configure the ETS bandwidth allocation and scheduling for priority traffic, create a QoS output policy.
Syntax
qos-policy-output policy-name ets
To remove the QoS output policy, use the no qos-policy-output ets
command.
Parameters
policy-name
1440
Enter the priority list value. Separate priority values with a
comma; specify a priority range with a dash; for example,
priority-list 3,5-7. The range is from 0 to 7.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
All 802.1p priorities are grouped in priority group 0.
100% of the port bandwidth is assigned to priority group 0. The complete
bandwidth is equally assigned to each priority class so that each class has 12 to
13%.
NOTE: Please note that Dell Networking does not recommended to use
this command as it has been deprecated in the current 9.4(0.0) release. A
warning message appears when you try to run this command indicating
that you have to use the dcb-map commands in the future.
priority-group qos-policy
output policy.
set-pgid — configures the priority-group.
Enter the policy name. The maximum is 32 characters.
— associates an ETS priority group with an ETS
PMUX Mode of the MXL 10/40GbE Switch I/O Module