Tunnel Destination - Dell MXL 10GbE Reference Manual

Defaults 0 (Mapped)
Command INTERFACE TUNNEL (conf-if-tu)
Modes
Command
Version 9.3(0.0)
History
Usage
This command configures the method used to set the high 6 bits (the differentiated
Information
services codepoint) of the IPv4 TOS or the IPv6 traffic class in the outer IP header.
A value of 0 copies original packet DSCP (IPv4)/Traffic Class (IPv6) to the tunnel
header DSCP (IPv4)/Traffic Class (IPv6) depending on the mode of tunnel.

tunnel destination

Set a destination endpoint for the tunnel.
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-
address | ipv6–address} command.
Parameters
ip-address
ipv6–address
Defaults none
Command INTERFACE TUNNEL (conf-if-tu)
Modes
Command
Version 9.3(0.0)
History
Usage
The tunnel interface is inoperable without a valid tunnel destination address for the
Information
configured Tunnel mode.
To establish a logical tunnel to the particular destination address, use the
destination address of the outer tunnel header. If you configure a tunnel interface
or source address, the tunnel destination must be compatible.
1300
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the destination IPv4 address for the tunnel.
Enter the destination IPv6 address for the tunnel.
Introduced on the MXL 10/40GbE Switch IO Module.
Tunneling