Bgp Default Local-Preference - Dell MXL 10GbE Reference Manual

bgp default local-preference

Change the default local preference value for routes exchanged between internal BGP peers.
Syntax
bgp default local-preference value
To return to the default value, use the no bgp default local-preference
command.
Parameters
value
Defaults 100
Command ROUTER BGP
Modes
Command
Version 9.2(0.0)
History
bgp enforce-first-as
Disable (or enable) enforce-first-as check for updates received from EBGP peers.
Syntax
bgp enforce-first-as
To turn off the default, use the no bgp enforce-first-as command.
Defaults Enabled.
Command ROUTER BGP
Modes
Command
Version 9.2(0.0)
History
Usage
This is enabled by default; that is, for all updates received from EBGP peers, BGP
Information
ensures that the first AS of the first AS segment is always the AS of the peer. If not,
the update is dropped and a counter is incremented. To view the failed enforce-
first-as check counter, use the show ip bgp ipv6 unicast neighbors
command.
If you disable enforce-first-as, view it using the show ip protocols
command.
IPv6 Border Gateway Protocol (IPv6 BGP)
Enter a number to assign to routes as the degree of
preference for those routes. When routes are compared, the
higher the degree of preference or local preference value,
the more the route is preferred. The range is from 0 to
4294967295. The default is 100.
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the MXL 10/40GbE Switch IO Module.
701