Interface Managementethernet - Dell MXL 10GbE Reference Manual

Version 8.3.16.1
Usage
You cannot delete a physical interface.
Information
By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To
place an interface in mode, ensure that the interface's configuration does not
contain an IP address and enter the Port Channel Commands command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the
next hop to the tunnel destination is over a physical interface. If you select any
other interface as the next hop to the tunnel destination, the tunnel interface does
not operate as an ECMP.
Example
Dell(conf)#interface tengig 0/0
Dell(conf-if-tengig-0/0)#exit#
Related
interface port-channel
Commands
interface vlan
show interfaces

interface ManagementEthernet

Configure the Management port on the system.
Syntax
interface ManagementEthernet slot/port
Parameters
slot/port
Defaults Not configured.
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
You cannot delete a Management port.
Information
The Management port is enabled by default (no shutdown). To assign an IP
address to the Management port, use the ip address command.
Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
1468
Introduced on the MXL 10/40GbE Switch IO Module.
— configures a port channel.
— configures a VLAN.
— displays the interface configuration.
Enter the keyword ManagementEthernet, then the slot
number (0 or 1) and port number zero (0).
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
PMUX Mode of the MXL 10/40GbE Switch I/O Module