Dell MXL 10GbE Reference Manual page 1488

Defaults Not configured.
Command INTERFACE VLAN — (conf-if-vl-n)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command.
Usage Queriers normally send some queries when a leave message is received prior to
Information deleting a group from the membership database. There may be situations when
you require a fast deletion of a group. When you enable IGMP fast leave
processing, the switch removes an interface from the multicast group as soon as it
detects an IGMP version 2 leave message on the interface.
ip igmp snooping last-member-query-interval
The last member query interval is the maximum response time inserted into Group-Specific queries sent
in response to Group-Leave messages.
Z9000 S4810 S4820TS6000
Syntax
ip igmp snooping last-member-query-interval milliseconds
To return to the default value, use the no ip igmp snooping last-member-
query-interval command.
Parameters
milliseconds
Defaults 1000 milliseconds
Command INTERFACE VLAN
Modes
1488
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the interval in milliseconds. The range is from 100 to
65535. The default is 1000 milliseconds.
PMUX Mode of the MXL 10/40GbE Switch I/O Module