Table of Contents
Advertisement
Parameters
channel-
number
Defaults
Not configured.
Command
CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by
Information
using the switchport command) or Layer 3 mode (by configuring an IP address).
You can add a Port Channel in Layer 2 mode to a VLAN.
A Port Channel can contain both 100/1000 interfaces and GE interfaces. Based on
the first interface configured in the Port Channel and enabled, the Dell Networking
OS determines if the Port Channel uses 100 Mb/s or 1000 Mb/s as the common
speed. For more information, refer to channel-member.
If the line card is in a Jumbo mode chassis, you can also configure the mtu and ip
mtu commands. The Link MTU and IP MTU values configured on the channel
members must be greater than the Link MTU and IP MTU values configured on the
Port Channel interface.
Example
Dell(conf)#int port-channel 2
Dell(conf-if-po-2)#
Related
channel-member
Commands
interface
interface vlan
shutdown
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in "oper up" status for the
LAG to be also in "oper up" status.
Syntax
minimum-links number
Parameters
number
PMUX Mode of the MXL 10/40GbE Switch I/O Module
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: In a Jumbo-enabled system, you must configure all members of a Port
Channel with the same link MTU values and the same IP MTU values.
— adds a physical interface to the LAG.
— configures a physical interface.
— configures a VLAN.
— disables/enables the port channel.
Enter the number of links in a LAG that must be in "oper up"
status. The range is from 1 to 16. The default is 1.
1481
Advertisement
Table of Contents
