Table of Contents
Advertisement
Related
show ip interface
Commands
ip route
Assign a static route to the switch.
Syntax
ip route {destination mask {ip-address | interface [ip-address]
| [distance] | [permanent] | tag tag-value}}
To delete a specific static route, use the no ip route destination mask
command.
To delete all routes matching a certain route, use the no ip route
destination mask command.
Parameters
destination
mask
ip-address
interface
distance
permanent
tag tag-value
632
— displays the interface routing status and configuration.
Enter the IP address in dotted decimal format of the
destination device.
Enter the mask in the slash prefix format (/x) of the
destination IP address.
Enter the IP address of the forwarding router in dotted
decimal format.
Enter the keyword interface then the slot/port number.
•
For a Loopback interface, enter the keyword loopback
then a number from zero (0) to 16383.
•
For the null interface, enter the keyword null then zero
(0).
•
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from
1 to 4094.
(OPTIONAL) Enter the value of the distance metric assigned
to the route. The range is from 1 to 255.
(OPTIONAL) Enter the keyword permanent to specify that
the route must not be removed even if the interface assigned
to that route goes down. The route must be currently active
to be installed in the routing table. If you disable the
interface, the route is removed from the routing table.
(OPTIONAL) Enter the keyword tag then a number to assign
to the route. The range is from 1 to 4294967295.
IPv4 Routing
Advertisement
Table of Contents
