Ip Msdp Sa-Limit - Dell MXL 10GbE Reference Manual

peer-address
access-list
name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History

ip msdp sa-limit

Configure the upper limit of source-active (SA) entries in SA-cache.
Syntax
ip msdp sa-limit number
To return to the default, use the no ip msdp sa-limit number command.
Parameters
number
Defaults 50000
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Usage The system counts the SA messages originated by itself and those messages
Information received from the MSDP peers. When the total SA messages reach this limit, the
subsequent SA messages are dropped (even if they pass RPF checking and policy
checking).
If the total number of SA messages is already larger than the limit when this
command is applied, those SA messages that are already in the software continue
to be accepted. To enforce the limit in such situation, use the clear ip msdp
sa-cache command.
Related
ip msdp peer
Commands
clear ip msdp peer
show ip msdp
894
Enter the peer address of the MSDP peer in a dotted decimal
format (A.B.C.D.).
Enter the name of an extended ACL that contains permitted
SAs. If you do not use this option, all local entries are
blocked.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the maximum number of SA entries in SA-cache. The
range is from 0 to 40000.
Introduced on the MXL 10/40GbE Switch IO Module.
— configures the MSDP peer.
— clears the MSDP peer.
— displays the MSDP information
Multicast Source Discovery Protocol (MSDP)