Logging Buffered - Dell MXL 10GbE Reference Manual

hostname
udp
tcp
Defaults Disabled.
Command CONFIGURATION
Modes
Command
Version 9.5(0.0)
History
Version 8.3.16.1
Related
logging on
Commands
Syslog server, and terminal lines.
logging trap

logging buffered

Enable logging and specify which messages are logged to an internal buffer. By default, all messages are
logged to the internal buffer.
Syntax
logging buffered [level] [size]
To return to the default values, use the default logging buffered command.
To disable logging stored to an internal buffer, use the no logging buffered
command.
Parameters
level
size
Simple Network Management Protocol (SNMP) and Syslog
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the name of a host already configured and recognized
by the switch.
Enter the keyword udp to enable transmission of log
message over UDP followed by port number. The default
port is 514
Enter the keyword tcp to enable transmission of log
message over TCP followed by port number.
Introduced udp and tcp keywords on the MXL 10/40GbE
Switch.
Introduced on the MXL 10/40GbE Switch IO Module.
— enables the logging asynchronously to logging buffer, console,
— enables logging to the Syslog server based on severity.
(OPTIONAL) Indicate a value from 0 to 7 or enter one of the
following equivalent words: emergencies, alerts,
critical, errors, warnings, notifications,
informational, or debugging. The default is 7 or
debugging.
(OPTIONAL) Indicate the size, in bytes, of the logging buffer.
The number of messages buffered depends on the size of
each message. The range is from 40960 to 524288. The
default is 40960 bytes.
1243