Pmux Mode Of The Mxl 10/40Gbe Switch I/O Module - Dell MXL 10GbE Reference Manual

PMUX Mode of the MXL 10/40GbE Switch
I/O Module
This chapter describes the various CLI commands applicable in PMUX mode.
Data Center Bridging (DCB)
Data center bridging (DCB) refers to a set of IEEE Ethernet enhancements that provide data centers with a
single, robust, converged network to support multiple traffic types, including local area network (LAN),
server, and storage traffic.
The Dell Networking Operating System (OS) commands for data center bridging features include
802.1Qbb priority-based flow control (PFC), 802.1Qaz enhanced transmission selection (ETS), and the
data center bridging exchange (DCBX) protocol.
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to
DCBX peers.
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-
tlv {fcoe | iscsi} command.
Parameters
{fcoe | iscsi}
Defaults Application priority TLVs are enabled to advertise FCoE and iSCSI.
Command PROTOCOL LLDP
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1

PMUX Mode of the MXL 10/40GbE Switch I/O Module

Enter the application priority TLVs, where:
• fcoe: enables the advertisement of FCoE in application
priority TLVs.
• iscsi: enables the advertisement of iSCSI in application
priority TLVs.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
64
1421