Vlan-Stack Access - Dell MXL 10GbE Reference Manual

Related dei mark
Commands

vlan-stack access

Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Usage
Prior to enabling this command, to place the interface in Layer 2 mode, enter the
Information
switchport command.
To remove the access port designation, remove the port (using the no member
interface command) from all stackable VLAN enabled VLANs.
vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
Syntax
vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, use the no vlan-stack
compatible command.
Defaults Not configured.
Command CONF-IF-VLAN
Modes
Command
Version 8.3.16.1
History
Usage
Prior to disabling the stackable VLAN feature, remove the members.
Information
To view the stackable VLANs, use the show vlan command in EXEC Privilege
mode. Stackable VLANs contain members, designated by the M in the Q column of
the command output.
1326
— sets the DEI value on egress.
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the MXL 10/40GbE Switch IO Module.
VLAN Stacking