•
If the IP SA of the incoming IGMP general query is higher than the VLAN IP address, the switch
continues to work as an IGMP snooping Querier.
ip igmp access-group
To specify access control for packets, use this feature.
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list
command.
Parameters
access-list
Defaults
Not configured
Command
INTERFACE (conf-if-interface-slot/port)
Modes
Command
Version 8.3.16.1
History
Usage
The access list accepted is an extended ACL. To block IGMP reports from hosts, on
Information
a per-interface basis based on the group address and source address that you
specify in the access list, use this feature.
ip igmp group-join-limit
To limit the number of IGMP groups that can be joined in a second, use this feature.
Syntax
ip igmp group-join-limit number
Parameters
number
Defaults
none
Command
CONFIGURATION (conf-if-interface-slot/port)
Modes
Command
Version 8.3.16.1
History
546
Enter the name of the extended ACL (16 characters
maximum).
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the number of IGMP groups permitted to join in a
second. The range is from 1 to 10000.
Introduced on the MXL 10/40GbE Switch IO Module.
Internet Group Management Protocol (IGMP)