Snmp-Server Packetsize - Dell MXL 10GbE Reference Manual

snmp-server packetsize

Set the largest SNMP packet size permitted. Wen the SNMP server is receiving a request or generating a
reply, use the snmp-server packetsize global configuration command.
Syntax
snmp-server packetsize byte-count
Parameters
byte-count
Defaults 8
Command CONFIGURATION
Modes
Command
Version 8.3.16.1
History
snmp-server trap-source
Configure a specific interface as the source for SNMP traffic.
Syntax
snmp-server trap-source interface
To disable sending traps out a specific interface, use the no snmp trap-source
command.
Parameters
interface
Defaults The IP address assigned to the management interface is the default.
Command CONFIGURATION
Modes
Command
Version 8.3.16.1
History
Usage To enable this snmp-server trap-source command, configure an IP address
Information
on the interface and enable the interface configured as an SNMP trap source.
1234
Enter one of the following values 8, 16, 24 or 32. Packet sizes
are 8000 bytes, 16000 bytes, 32000 bytes, and 64000 bytes.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Introduced on the MXL 10/40GbE Switch IO Module.
Simple Network Management Protocol (SNMP) and Syslog