Redirect - Dell MXL 10GbE Reference Manual

bit
operator
Defaults none
Command REDIRECT-LIST
Modes
Command
Version 9.4(0.0)
History
Version 8.4.2.1
Version 8.4.2.0
Version 7.5.1.0

redirect

Configure a rule for the redirect list.
Syntax
redirect {ip-address | slot/port} {ip-protocol-number |
protocol-type [bit]} {source mask | any | host ip-address}
{destination mask | any | host ip-address} [operator]
To remove this filter, use one of the following:
•
•
Policy-based Routing (PBR)
(OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
(OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two
ports for the portcommand parameter.)
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
Introduced on the E-Series ExaScale.
Use the no seq sequence-number command if you know the filter's
sequence number.
You can also use the no redirect {ip-address | slot/port} {ip-
protocol-number [bit] | protocol-type} {source mask | any |
1007