Primary-Priority - Dell MXL 10GbE Reference Manual

primary-priority

Reconfigure the primary role of VLT peer switches.
Syntax
primary-priority value
Parameters
value
Default 32768
Command VLT DOMAIN
Modes
Command
Version 9.2(0.0)
History
Usage After you configure the VLT domain on each peer switch on both sides of the
Information interconnect trunk, by default, the software elects a primary and secondary VLT
peer device. To reconfigure the primary role of VLT peer switches, use the
priority command.
show ip mroute
View the multicast routing table.
Syntax
show ip mroute [static | group-address [source-address] | count
| snooping [vlan vlan-id] [group-address [source-address]] |
summary | vlt [group-address | count]
Parameters
Static
group-address
[source-
address]
count
snooping [vlan
vlan-id]
[group-address
[source-
address]]
Virtual Link Trunking (VLT)
To configure the primary role on a VLT peer, enter a lower
value than the priority value of the remote peer. The range is
from 1 to 65535.
Introduced on the MXL 10/40GbE Switch IO Module.
(OPTIONAL) Enter the keyword static to view static
multicast routes.
(OPTIONAL) Enter the multicast group-address to view only
routes associated with that group.
Enter the source-address to view routes with that group-
address and source-address.
(OPTIONAL) Enter the keyword count to view the number of
multicast routes and packets.
(OPTIONAL)
Enter the keyword snooping to display information on the
multicast routes PIM-SM snooping discovers.
Enter a VLAN ID to limit the information displayed to the
multicast routes PIM-SM snooping discovers on a specified
VLAN. The VLAN ID range is from 1 to 4094.
1335