Edge-Port Bpdufilter Default - Dell MXL 10GbE Reference Manual

Command CONFIGURATION (conf-pvst)
Modes
Command
Version 8.3.16.1
History
Related
protocol spanning-tree pvst
Commands

edge-port bpdufilter default

Enable BPDU Filter globally to filter transmission of BPDU on port fast enabled interfaces.
Syntax
edge-port bpdufilter default
To disable global bpdu filter default, use the no edge-port bpdufilter
default command.
Defaults Disabled
Command CONFIGURATION (The prompt is "config-pvst".)
Modes
Command
Version 8.3.16.1
History
extend system-id
To augment the Bridge ID with a VLAN ID so that PVST+ differentiate between BPDUs for each VLAN, use
extend system ID. If the VLAN receives a BPDU meant for another VLAN, PVST+ does not detect a loop,
and both ports can remain in Forwarding state.
Syntax
extend system-id
Defaults Disabled
Command PROTOCOL PVST
Modes
Command
Version 8.3.16.1
History
Example
Dell(conf-pvst)#do show spanning-tree pvst vlan 2 brief
VLAN 2
Executing IEEE compatible Spanning Tree Protocol
Root ID
Root Bridge hello time 2, max age 20, forward delay 15
Bridge ID
We are the root of Vlan 2
Configured hello time 2, max age 20, forward delay 15
Bpdu filter disabled globally
Per-VLAN Spanning Tree Plus (PVST+)
Introduced on the MXL 10/40GbE Switch IO Module.
— enter PVST+ mode.
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the MXL 10/40GbE Switch IO Module.
Priority 32768, Address 001e.c9f1.00f3
Priority 32768, Address 001e.c9f1.00f3
1061