Debug Ip Rip - Dell MXL 10GbE Reference Manual

debug ip rip

Examine RIP routing information for troubleshooting.
Syntax
debug ip rip [interface | database | events [interface] |
packet [interface] | trigger]
To turn off debugging output, use the no debug ip rip command.
Parameters
interface
database
events
trigger
Command EXEC Privilege
Modes
Command
Version 8.3.16.1
History
default-information originate
Generate a default route for the RIP traffic.
Syntax
default-information originate [always] [metric metric-value]
[route-map map-name]
To return to the default values, use the no default-information originate
command.
Parameters
always
1114
(OPTIONAL) Enter the interface type and ID as one of the
following:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
(OPTIONAL) Enter the keyword database to display
messages when there is a change to the RIP database.
(OPTIONAL) Enter the keyword events to debug only RIP
protocol changes.
(OPTIONAL) Enter the keyword trigger to debug only RIP
trigger extensions.
Introduced on the MXL 10/40GbE Switch IO Module.
(OPTIONAL) Enter the keyword always to enable the switch
software to always advertise the default route.
Routing Information Protocol (RIP)