Link Aggregation Control Protocol (Lacp) - Dell MXL 10GbE Reference Manual

Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage For details about using this command, refer to the "NIC Teaming" section of the
Information Layer 2 chapter in the Dell Networking OS Configuration Guide.

Link Aggregation Control Protocol (LACP)

This chapter contains commands for Dell Networks's implementation of the link aggregation control
protocol (LACP) for creating dynamic link aggregation groups (LAGs) — known as port-channels in the
Dell Networking Operating System (OS).
NOTE: For static LAG commands, refer to the
in the IEEE 802.3 Carrier sense multiple access with collision detection (CSMA/CD) access method
and physical layer specifications.
lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-
timeout command.
Defaults 1 second
Command INTERFACE (conf-if-po-number)
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage This command applies to dynamic port-channel interfaces only. When applied on a
Information static port-channel, this command has no effect.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Interfaces chapter), based on the standards specified
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
1493