Command
SPANNING TREE (The prompt is "config-rstp".)
Modes
Command
Version 8.3.16.1
History
Related
protocol spanning-tree rstp
Commands
disable
Disable RSTP globally on the system.
Syntax
disable
To enable Rapid Spanning Tree Protocol, use the no disable command.
Defaults
RSTP is disabled.
Command
CONFIGURATION RSTP (conf-rstp)
Modes
Command
Version 8.3.16.1
History
Related
protocol spanning-tree rstp
Commands
forward-delay
Configure the amount of time the interface waits in the Listening State and the Learning State before
transitioning to the Forwarding State.
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
seconds
Defaults
15 seconds
Command
CONFIGURATION RSTP (conf-rstp)
Modes
Command
Version 8.3.16.1
History
1144
Introduced on the MXL 10/40GbE Switch IO Module.
— enters SPANNING TREE mode on the switch.
Introduced on the MXL 10/40GbE Switch IO Module.
— enters SPANNING TREE mode on the switch.
Enter the number of seconds that the system waits before
transitioning RSTP to the forwarding state. The range is from
4 to 30. The default is 15 seconds.
Introduced on the MXL 10/40GbE Switch IO Module.
Rapid Spanning Tree Protocol (RSTP)