Ip Pim Dr-Priority - Dell C9000 Series Reference Manual

ip pim dr-priority

Change the designated router (DR) priority for the interface.
C9000 Series
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority
command.
Parameters
priority-value
Defaults 1
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.5(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
Usage Information The router with the largest value assigned to an interface becomes the designated
router. If two interfaces contain the same designated router priority value, the interface
with the largest interface IP address becomes the designated router.
Enter a number. Preference is given to larger/higher number.
The range is from 0 to 4294967294. The default is 1.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series on port-channels and the S-Series.
PIM-Source Specific Mode (PIM-SSM) 1659