Mac-Address-Table Station-Move Refresh-Arp - Dell MXL 10GbE Reference Manual

vlan vlan-id
Defaults Not configured.
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1

mac-address-table station-move refresh-arp

Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs
due to a topology change.
Syntax
[no] mac-address-table station-move refresh-arp
Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage For details about using this command, refer to the "NIC Teaming" section of the
Information Layer 2 chapter in the Dell Networking OS Configuration Guide.
mac learning-limit
Limit the maximum number of MAC addresses (static + dynamic) learned on a selected interface.
Syntax
mac learning-limit address_limit [dyanmic] [no-station-move|
station-move][sticky]
Parameters
address_limit
848
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keyword vlan then a VLAN ID number from 1 to
4094.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the maximum number of MAC addresses that can be
learned on the interface. The range is from 1 to 1000000.
Layer 2