Clear Ipv6 Mld_Host - Dell MXL 10GbE Reference Manual

clear ipv6 mld_host

Clear the IPv6 MLD host counters and reset the elapsed time.
Syntax
clear ipv6 mld_host
Command EXEC
Modes
Command
Version 9.2(0.0)
History
ipv6 address autoconfig
Configure IPv6 address auto-configuration for the management interface.
Syntax
ipv6 address autoconfig
To disable the address autoconfig operation on the management interface, use the
no ipv6 address autoconfig command.
Default Disabled
Command INTERFACE (management interface only)
Modes
Command
Version 9.2(0.0)
History
Usage
•
Infomation
•
•
•
•
•
674
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the MXL 10/40GbE Switch IO Module.
SAA can configure up to two addresses. If any preferred prefix or valid timers
time out, the corresponding address are deprecated or removed. If an address
is removed due to a time-out, an address from the current unused prefix is used
to create a new address. If there are no remaining prefixes, the software waits
to receive a new prefix from the RA.
If auto-configuration is enabled, all IPv6 addresses on that management
interface are auto-configured. Manual and auto-configurations are not
supported on a single management interface.
Removing auto-configuration removes all auto-configured IPv6 addresses and
the link-local IPv6 address from that management interface.
IPv6 addresses on a single management interface cannot be members of the
same subnet.
IPv6 secondary addresses on management interfaces across a platform must be
members of the same subnet.
IPv6 secondary addresses on management interfaces should not match the
virtual IP address and should not be in the same subnet as the virtual IP.
IPv6 Basics