Multiplier - Dell MXL 10GbE Reference Manual

Version 8.3.16.1
Related
protocol lldp (Configuration)
Commands
show lldp neighbors

multiplier

Set the number of consecutive misses before LLDP declares the interface dead.
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer
Defaults 4 x hello
Command CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Enabled.
Command CONFIGURATION (conf-lldp)
Modes
Command
Version 8.3.16.1
History
Link Layer Discovery Protocol (LLDP)
Introduced on the MXL 10/40GbE Switch IO Module.
— enables LLDP globally.
— displays the LLDP neighbors.
Enter the number of consecutive misses before the LLDP
declares the interface dead. The range is from 2 to 10.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the MXL 10/40GbE Switch IO Module.
871