Cam-Acl-Egress - Dell MXL 10GbE Reference Manual

l2acl 1-10
ipv4acl 1-10
ipv6acl 0-10
ipv4qos 1-10
l2qos 1-10
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Usage
For the new settings to take effect, save the new CAM settings to the startup-
Information
config (write-mem or copy run start), then reload the system.
The total amount of space allowed is 16 FP blocks. System flow requires three
blocks and these blocks cannot be reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile
which is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).

cam-acl-egress

Allocate space for IPv6 egress ACLs.
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default
l2acl 1-4
ipv4acl 1- 4
ipv6acl 0-4
Command CONFIGURATION
Modes
IPv6 Access Control Lists (IPv6 ACLs)
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
Allocate space to support IPv6 ACLs. Enter all of the profiles
and a range. Enter the CAM profile name then the amount to
be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
Introduced on the MXL 10/40GbE Switch IO Module.
Use the default CAM profile settings, and set the CAM as
follows:
• L2 ACL(l2acl): 1
• L3 ACL (ipv4acl: 1
• IPv6 L3 ACL (ipv6acl): 2
Allocate space to support IPv6 ACLs. Enter all of the profiles
and a range. Enter the CAM profile name then the amount to
be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
665