Table of Contents
Advertisement
•
•
Example (Bulk)
Dell(conf)#interface range so 2/0-1, te 10/0, gi 3/0, fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example
Dell(conf)#interface range gi 2/0 - 23, gi 2/1 - 10
(Multiple Ports)
Dell(conf-if-range-gi-2/0-23#
Example
Dell(conf)#interface range gi 2/1 - 11, gi 2/1 - 23
(Overlapping
Dell(conf-if-range-gi-2/1-23#
Ports)
Usage
Only VLAN and port-channel interfaces created using the interface vlan and
Information
interface port-channel commands can be used in the interface range
command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the show
running-config command cannot be used with the bulk configuration feature of
the interface range command. You cannot create virtual interfaces (VLAN,
Port-channel) using the interface range command.
Example (Single
This example shows a single range bulk configuration.
Range)
Dell(config)# interface range gigabitethernet 5/1 - 23
Dell(config-if-range)# no shutdown
Dell(config-if-range)#
Example
This example shows how to use commas to add different interface types to the
(Multiple
range enabling all Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both
Range)
Ten-Gigabit Ethernet interfaces 1/1 and 1/2.
Dell(config-if)# interface range gigabitethernet5/1-23,
tengigabitethernet1/1-2
Dell(config-if-range)# no shutdown
Dell(config-if-range)#
Example
This example shows how to use commas to add SONET, VLAN, and port-channel
(Multiple
interfaces to the range.
Range)
Dell(config-if)# interface range gigabitethernet5/1-23,
tengigabitethernet1/1–2,
1470
characters. If the bulk configuration exceeds 32 characters, it is represented by
an ellipsis ( ... ).
When the interface range prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
If overlapping port ranges are specified, the port range is extended to the
smallest start port and the biggest end port.
NOTE: If a range has VLAN, physical, port-channel, and SONET interfaces, only
commands related to physical interfaces can be bulk configured. To configure
commands specific to VLAN or port-channel, only those respective interfaces
should be configured in a particular range.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Advertisement
Table of Contents
