Storm-Control Multicast (Interface) - Dell MXL 10GbE Reference Manual

storm-control multicast (Interface)

Configure the percentage of multicast traffic allowed on an MXL switch interface (ingress only).
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control
multicast packets_per_second in command.
Parameters
packets_per_se
cond
Defaults none
Command INTERFACE (conf-if-interface-slot/port)
Modes
Command
Version 8.3.16.1
History
storm-control unknown-unicast (Configuration)
Configure the percentage of unknown-unicast traffic allowed on an MXL switch (ingress rate only).
Syntax
storm-control unknown-unicast [packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control
unknown-unicast [packets_per_second in] command.
Parameters
packets_per_se
cond
Defaults none
Command CONFIGURATION
Modes
Command
Version 8.3.16.1
History
Usage Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces.
Information
1268
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Introduced on the MXL 10/40GbE Switch IO Module.
Storm Control