Ip Max-Frag-Count - Dell MXL 10GbE Reference Manual

Defaults Not configured.
Command CONFIGURATION
Modes
Command
Version 9.3(0.0)
History
Usage You can enable the mechanism to configure the source or the originating interface
Information from which the packet (the device that generates the ICMP error messages) is
received by the switch to send the loopback address instead of its source IP
address to be used in the ICMP unreachable messages and in the traceroute
command output. The loopback address must be unique in a particular domain.
In network environments that contain a large number of devices, ranging up to
thousands of systems, and with each device configured for equal-cost multipath
(ECMP) links, you cannot effectively and optimally use the traceroute and ping
applications to examine the network reachablity and identify any broken links for
diagnostic purposes. In such cases, if the reply that is obtained from each hop on
the network path contains the IP address of the adjacent, neighboring interface
from which the packet is received, it is difficult to employ the ping and traceroute
utilites. You can enable the ICMP unreachable messages to contain the loopback
address of the source device instead of the previous hop's IP address to be able to
easily and quickly identify the device and devices along the path because the DNS
server maps the loopback IP address to the hostname and does not translate the IP
address of every interface of the switch to the hostname.
Example
Dell(conf)#ipv6 icmp source-interface tengigabitethernet 0/0
Dell(conf)#

ip max-frag-count

Set the maximum number of fragments allowed in one packet for packet re-assembly.
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, use the no ip max-frag-
count command.
Parameters
count
Defaults No limit is set on number of fragments allowed.
Command CONFIGURATION
Modes
Command
Version 8.3.16.1
History
630
Introduced on the MXL platform.
Enter a number for the number of fragments allowed for re-
assembly. The range is from 2 to 256.
Introduced on the MXL 10/40GbE Switch IO Module.
IPv4 Routing