vlt domain
Enable VLT on a switch, configure a VLT domain, and enter VLT-domain configuration mode.
Syntax
vlt domain domain-id
Parameters
domain-id
Command
CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to
an attached device.
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number
Defaults
Not configured.
Command
INTERFACE PORT-CHANNEL
Modes
Command
Version 9.2(0.0)
History
show vlt private-vlan
Display the association of private VLAN (PVLAN) with the VLT LAG. You can configure VLT peer nodes in a
PVLAN on the MXL switch.
Syntax
show vlt private-vlan
Command
EXEC
Modes
Command
Version 9.3(0.0)
History
Virtual Link Trunking (VLT)
Enter the Domain ID number. Configure the same domain ID
on the peer switch. VLT uses the domain ID to automatically
create a VLT MAC address for the domain. The range of
domain IDs is from 1 to 1000.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the port-channel number that connects to another
port channel in the VLT peer. The range is from 1 to 128.
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the MXL 10/40GbE Switch IO Module
platform.
1343