Snmp-Server Host - Dell MXL 10GbE Reference Manual

snmp-server host

Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address [traps | informs] [version 1 | 2c |
3] [auth | no auth | priv] [community-string] [udp-port port-
number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address
[traps | informs] [version 1 | 2c | 3] [auth | noauth | priv]
[community-string] [udp-port number] [notification-type]
command.
Parameters
ip-address
traps
informs
version 1 | 2c |
3
auth
noauth
priv
community-
string
Simple Network Management Protocol (SNMP) and Syslog
Enter the keyword host then the IP address of the host
(configurable hosts is limited to 16).
(OPTIONAL) Enter the keyword traps to send trap
notifications to the specified host. The default is traps.
(OPTIONAL) Enter the keyword informs to send inform
notifications to the specified host. The default is traps.
(OPTIONAL) Enter the keyword version to specify the
security model then the security model version number 1,
2c, or 3:
• Version 1 is the least secure version.
• Version 3 is the most secure of the security modes.
• Version 2c allows transmission of informs and counter
64, which allows for integers twice the width of what is
normally allowed.
The default is version 1.
(OPTIONAL) Enter the keyword auth to specify
authentication of a packet without encryption.
(OPTIONAL) Enter the keyword noauth to specify no
authentication of a packet.
(OPTIONAL) Enter the keyword priv to specify both
authentication and then scrambling of the packet.
Enter a text string (up to 20 characters long) as the name of
the SNMP community.
NOTE: For version 1 and version 2c security models, this
string represents the name of the SNMP community. The
string can be set using this command; however, Dell
Networking OS recommends setting the community
string using the snmp-server community command
before executing this command. For version 3 security
model, this string is the USM user security name.
1231