Command
Version 9.2(0.0)
History
ip pim register-filter
To prevent a PIM source DR from sending register packets to an RP for the specified multicast source and
group, use this feature.
Syntax
ip pim register-filter access-list
To return to the default, use the no ip pim register-filter access-list
command.
Parameters
access-list
Defaults
Not configured.
Command
CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Usage
The access name is an extended IP access list that denies PIM register packets to
Information
RP at the source DR based on the multicast and group addresses. Do not enter this
command before creating the access-list.
ip pim rp-address
Configure a static PIM rendezvous point (RP) address for a group or access-list.
Syntax
ip pim rp-address address {group-address group-address mask}
override
To remove an RP address, use the no ip pim rp-address address {group-
address group-address mask} override command.
Parameters
address
group-address
group-address
mask
override
PIM-Sparse Mode (PIM-SM)
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the name of an extended access list. Maximum 16
characters.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the RP address in dotted decimal format (A.B.C.D).
Enter the keywords group-address then a group-address
mask, in dotted decimal format (/xx), to assign that group
address to the RP.
Enter the keyword override to override the BSR updates
with static RP. The override takes effect immediately during
enable/disable.
1019